Self-Test Diagnostics
WARNING:
This test is a key on engine off (koeo) test only that is conducted in park only with emergency brake fully engaged.
l Enter Self-Test Diagnostics by depressing the speed control OFF switch while turning the ignition key ON, ensuring engine does not start and is not running. The speed control indicator lamp on the instrument panel will flash once to indicate that the speed control module entered the diagnostic mode.
Note:
Five additional flashes at this point indicate a defective speed control servo. Release the OFF switch.
l Release the OFF switch.
l Note:
If the ON switch is not pressed within 5 seconds after entering the diagnostic mode, the module times out and the procedure must be started over.
Press the remaining switches in this sequence: ON, RSM (resume), CST (coast), and SET/ACCEL. The speed control indicator lamp will flash as each switch is pressed. Press each switch in the sequence immediately after the light goes out for the previous switch.
l A lamp flash with the last button (SET/ACCEL) indicates that the STATIC test passed. If the lamp does not flash with the last button and there are no additional flashes of the lamp, the switch is defective. If the lamp does not flash with the last button, and additional flashes occur, follow the chart below for trouble codes:
— 2 flashes - Brake pedal position (BPP) switch is defective, circuit is defective, or brake pedal is applied; clutch pedal position (CPP) switch is defective, circuit is defective, or clutch pedal is applied.
— 3 flashes - Brake deactivation switch is open or circuit is defective.
— 4 flashes - Vehicle speed signal is out of range or circuit is defective.
l Immediately after the static test has passed, the speed servo will then perform a dynamic test automatically by actuating the throttle lever from 1mm to 10 mm of travel from the idle position. During the dynamic throttle pull, observe the throttle movement to witness any binding or sticking of actuator cable, proper connection of actuator cable to throttle lever, and ensure throttle returns back to idle position. If improper connection and/or binding or sticking of actuator is observed, go to Symptom Chart.
l Return ignition switch to the OFF position and proceed to Symptom Chart.
